• Hi, if you have stumbled across here, welcome to our test site. This site is a working replica of the main aawforum.org website where we test and evalute new features and software updates. While you can login and post here, push notifications and email notifications have been disabled and any and all content on this site will be delelted with no notice. So please feel free to look around at our pile of shavings while we continue to refine the AAW Forums but please do not post any real messages here as no one will see them. Thanks!
  • Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.

Baxter's Threadmaster for Vicmarc VL 100 (10 inch swing) Colorado Springs, Co

Status
Not open for further replies.
D

Dr. Bob

Joined
Apr 6, 2007
Messages
11
Likes
0
I'm selling this for the widow of a club member. It's never been used. The Best Tools site lists it at $ 500 and it also has two 2 inch face plates listed at $ 60 so a value of $ 560 if my math is correct. The Best Tools site also says it is for lathes with a 9" to 12 1/2" swings with the right height riser. This one has the 10" one for the VL 100 or the Jet 1014. The cutter is TC 75, 3/4 inch.

Asking $ 400 plus shipping (it should fit into a large flat rate USPS box $ 21 or so).
(Or available for pick up in Monument, Colorado)

Robert Gibbs
E mail bobandcamilla@comcast.net
Home phone 719 488 9487Baxter's Threadmaster.jpeg
 
Status
Not open for further replies.
Top